Motion Detector Plus

Detect, verify, control

Dual motion detector

The Motion Detector Plus uses two types of sensors to detect movement: an infrared (PIR) sensor and a microwave (MW) sensor. In addition to the high efficiency in detecting a moving person, it comes with a reduced risk of false alarms. And all this for your security and peace of mind.

Impressive detection area

The modern wide-angle lens (90°) allows monitoring of an area with 15 m x 24 m impressive surface. Thanks to this, Motion Detector Plus will provide effective supervision of a spacious living room or even a very large garage.

No blind spots

The Motion Detector Plus offers optional creep zone protection, which means that the detector also keeps an eye on the space directly below it.

Communication even over long distances

Communication between the Motion Detector and the Smart HUB takes place via radio and has a very large range. Owing to this, the detector is perfect for both smaller and larger homes, flats and even commercial premises.

No more false alarms

The Motion Detector Plus monitors temperature changes in its supervision area, then uses a microwave detector to confirm whether the heat fluctuation was caused by a moving person and not, for example, a draught or a switched-on air conditioner. This makes the information transmitted to the Smart HUB more reliable and the risk of a false alarm occurrence is minimized.

Smart use of detection

Movement detected by the Motion Detector Plus can trigger a number of functions in your smart home. Make the most of the full potential offered by this advanced detector.

Beggining of the day

In the morning, the Motion Detector Plus detects your movement, which becomes a signal for the Smart HUB to trigger a scenario to wake your home from sleep!

Kliknij tutaj

Light where you are

A forgotten switched-on light in a room is no longer a concern. The Smart HUB monitors the time of inactivity in the room. If after a specified time the Detector does not report motion detection, the light will go out.

When you enter the room in the evening, the lighting will respond to your movement and switch on automatically.

Kliknij tutaj

Smart heating

The Motion Detector Plus constantly informs the Smart HUB of activity in the room. If the sensor registers prolonged inactivity, the heating can be switched to the ECO mode.

Kliknij tutaj

One device, many possibilities

The Motion Detector Plus is fitted with a temperature sensor, which allows efficient management of the heating system. You can configure the system to automatically adjust the heating depending on whether a certain temperature threshold is reached.

Convenient installation

You can attach the Motion Detector Plus to the wall easily and conveniently with a special mounting tape or screws. If additional adjustment of the device’s position is needed, such as tilting it, a special BRACKET D holder is available.

Enclosure tampering detection

The Motion Detector Plus features a special sensor that reacts to any attempt to open or detach the detector bolted to the wall. In the case of such tampering, BE WAVE will trigger an alarm and you will receive an immediate push notification.

Ideally, install in...

As the Motion Detector Plus uses two detection paths, it is perfectly suited to rooms exposed to frequent temperature changes, such as garages, rooms with a fireplace or air conditioner, as well as vestibules.

Easy configuration in the app

You can easily add a detector to your system and conveniently configure its settings in the app. You can choose one of three levels of motion detection sensitivity. The Motion Detector Plus can perform security functions, automation functions or both at the same time – it’s all up to you!